Riverside Hydronics 2000 WB 250A-IF Guía para resolver problemas descargar pdf (Pagina 35)

34-53 08/14

6. The combustion air filter should be replaced every six months. If filter blockage becomes excessive the filter

safety switch will not allow the burner to fire. To avoid nuisance shutdown in dirty environments, check and

replace filter more frequently. See Filter Replacement Illustration below for removal detail.

7. Inspect low water cutoffs and relief valves for proper operation at every six months, or more often if indicated

by inspection.

8. Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors and

liquids.

9. Check frequently to be sure the flow of combustion and ventilation air is unobstructed to the appliance.

10. When electrical controls are serviced or replaced refer to ELECTRICAL COMPONENT LOCATIONS for

identification and location of components.

11. All replacement parts are available through your Riverside Hydronics

Dealer. If you need assistance

identifying or contacting your local dealer, you may contact Riverside Hydronics directly at the address and

telephone number located on the first and last page of this manual.

12. If the appliance is to be shut down for an extended period of time, the primary gas valve and the water supply

should be shut off. When the appliance is returned to service, a thorough inspection of all utilities and general

appliance condition should be conducted.

FILTER REPLACEMENT ILLUSTRATION

REMOVE FILTER BOX

ACCESS COVER TO

REPLACE FILTER.

NOMINAL FILTER SIZE

12 X 24 PLEATED

1 2 ... 30 31 32 33 34 35 36 37 38

Sin comentarios

Riverside Hydronics 2000 WB 250A-IF Guía para resolver problemas Pagina 35